System information

ATS2000/3000/4000/4500 Programming manual
114
NO
–
Entry/Exit Shunting
*-Change 0 - Skip
NO
–
Log Door Open/Close
*-Change 0 - Skip
21.1.12. Entry/exit shunting
Allows the shunted zone to be treated as an entry/exit zone.
YES A code must be entered to start the shunting or before the shunt timer expires,
otherwise an alarm is generated.
NO The shunted zone is not treated an entry/exit zone.
 Press 0 to end programming this shunt timer and to select a new shunt
timer.
 If this option is set to YES, the “Door open command" must be set to NO.
21.1.13. Log door open/close
Allow for the zone to be logged on printer as door open/close when it switches between
normal and active.
YES Every time the zone changes status, it is logged to the printer.
NO No reporting to the printer.
 Press 0 to end programming this shunt timer and to select a new shunt
timer.
 If Print zone when is set to YES in the Zone database (page 17) for the zone
assigned to the shunt timer, a door open message is sent twice.