Programming instructions

1. New Master Code (User Number 1)

2. Add/Delete/Change User Codes 2-300

; 1 ; [ _ _ _ _ _ _ ] ; [ _ _ _ _ _ _ ] :

Users programmed with Function 2 will default to a Group

Association and a Program Level Ability as follows:

USER TYPE USER NUMBER DEFAULT

GROUP ASSOCIATION

PROGRAM

LEVEL ABILITY

Master Code 1 none 1, 2, 3, 4, Master

Manager Codes 2 - 6 none 1, 2, 3

Supervisor 7 - 11 none 1, 2

Basic User Codes 12 - 50 none none

Basic User Codes Group 1 51 - 100 1 none

Basic User Codes Group 2 101 - 150 2 none

Basic User Codes Group 3 151 - 200 3 none

Basic User Codes Group 4 201 - 250 4 none

Basic User Codes 251 - 298 none none

Non-Pass Code 299 none none

Service Code 300 none none

3. Disable User

; 3 ; [ _ _ _ ] :

(User Number)

; 2 ; [ _ _ _ ] ; [ _ _ _ _ _ _ ] :

4. Enable User

; 4 ; [ _ _ _ ] :

(User Number)

Enabling/Disabling Users (By User Number)

• User Number must be between 2 and 300.

• To delete a code, leave the User Code blank

• User Code must be 3-6 digits

• Master Code must be 6 digits-only.

NOTE: Following a power up, Function 1 (New Master Code), must be accessed before

any other programming function is permitted.

USERS

• User Number must be between 2 and 300

NOTE: Will Enable/Disable users even if the user is associated with a enabled group.

User 299 is a Non-Pass Code. This is the only code that will initiate data transfer with the AL-DTM. This code can be assigned

program ability to allow printing the log to the handheld printer without allowing the user to pass through the door. This code may

be used to record a guard’s location in a building while “making his rounds”.

NOTE: