Programming instructions

10
Keypad Programming
Entering Program Mode
1. Enter Master Code 1 2 3 4 5 6
Default Master Code
2. Enter ;
Program the Master Code before programming any other
Functions (New Lock or following a power up).
New Master Code (User Number 1)
; 1 ; [ _ _ _ _ _ _ ] ; [ _ _ _ _ _ _ ] :
New Master Code Confirm Master Code
Exiting Program Mode
There are 2 ways to exit Program Mode:
1. Hold down any key for 3 seconds
2. Press no keys for 3 minutes
(Program Mode Timeout).
Downloading
“BeepBeep” “BeepBeep” “BeepBeep” “BeepBeep”
Sounder will sound 2 short beeps 4 times to indicate
the program mode is active.
The DL3000 lock can also be programmed using
a computer and Alarm Lock's
DL-WINDOWS Software.
Tri-Color
Infrared LED
PC Interface/AL-DTM
Program Mode
The keypad sounder will beep every 6 seconds
and the keypad LED will flash green every 6
seconds while in program mode when no keys
are pressed. NOTE: There is a 3 minute
Program Mode Timeout if no keys are pressed
while in Program Mode. A steady tone will
sound indicating there is 15 seconds left to
press a key or Program Mode will timeout.
2 series of 4 Quick Beeps once
the Exit Sequence has initiated.
“BeepBeepBeepBeep” “BeepBeepBeepBeep”
6 - Slow Beeps
“Beep” “Beep” “Beep” “Beep” “Beep” “Beep”
End of Exit Sequence
“BeepBeep”
The DL3000 lock can also be programmed using
Alarm Lock's AL-DTM Data Transfer Module and
a computer running Alarm Lock's DL-WINDOWS
Software.
AL-DTM
DL3500 Lock (mounted on door)
-
+
NOTE: Observe Tab Direction
when inserting cable into DL3500 Lock.
-
+
(Tab to the left)
PLUG IN THEN
ENTER YOUR CODE
AL-DTM
DL3500 Lock (mounted on door)
IBM COMPATIBLE
LAPTOP COMPUTER
TO SERIAL PORT (DB-9)
E.G. <COM 1>
AL-PCI
-
+
NOTE: Observe Tab Direction
when inserting cable into DL3500 Lock.
Note: AL-DTM
has been
configured using
a computer
running DL-
WINDOWS
software. Refer to
DL-WINDOWS
Software