Operating instructions

2.14 System Operator Codes
There are three levels of operator codes: USER, DURESS and MANAGER
The MANAGER codes are the highest level permitting access into the MANAGER MENU,
and allowing the setting/ unsetting of all levels of the security system.
The USER codes are the lowest level, and do NOT allow access into the MANAGER MENU,
and permit the setting/ unsetting of predetermined security areas only.
The DURESS code permits the system to be unset in the normal way, but will generate an
immediate silent alarm signal to an Alarm Receiving Centre. This code should not be used if
the monitoring facility is not connected.
When supplied from the factory, only one code is programmed. This is code 1, which is
designated a 'Manager' code, and is pre-set to 1234. To change this code, refer section 4.1.
2.15 Engineer Programming Code
The Alarm Installation Company Engineer has a special code to enable him to program the
system.
This code will also enable him to set and unset the system whilst testing, etc; but he will NOT
be able to unset the system if set by one of your codes.
2.16 Fire Alarm
Whilst not complying with full Fire Alarm requirements, the system has the capability to
accept some fire alarm detectors. In the event of one of such triggering, the system will sound
a full alarm, with an interrupted tone on the loudspeaker, and pulsed output on the external
sounder, to distinguish it from the normal intruder alarm sound.
2000 Series Alarm System Operating Instructions
December 2000 Page 9