Specifications

3
Installation & Mounting
Select the desired mounting location for the lightbar. This product is attached with 3/8" carriage
bolts whose centerlines are 2" below the top of the lightbar (Figure 1).
Locate the bolts along the back of the lightbar. The number of mounting bolts varies with the
length of the lightbar. Place a mounting bolt near each end of the frame. Space additional bolts
evenly across the remaining length. Locate 7/16" diameter clearance holes on the vehicle to work
with the bolt locations. Locate for easy access from the inside of the vehicle. Locate and drill a
minimum 3/4” diameter hole for the control cable exiting as shown in Figure 2 below. Insure the
cable jacket cannot be cut by sharp edges.
Route the cable and the bolts into their respective holes. Attach the washers and nuts to the bolts
from the inside of the vehicle. Apply caulk to all bolts and wires at the point of entry.
2.0
1.2
UPPER LENS
LOWER LENS
FRAME
AMBULANCE
SHEET METAL
T06732 - STEP BOLT 3/8-16 X 1.5"
T01578 - 3/8 FLAT WASHER
T06533 - 3/8 LOCK WASHER
T06551 - 3/8 HEX NUT
MOUNTING ASSEMBLY/HARDWARE FOR XP9500
C
L
C
L
C
L
C
L
C
L
C
L
6 9/32"
C
L
6 9/32"
6 9/32"
2 POD1 POD 3 POD
4 POD
5 POD
6 POD
7 POD
STANDARD CABLE HOLE LOCATIONS FOR XP9500 FROM CENTERLINE OF BAR
FIGURE 1
FIGURE 2