Troubleshooting guide

ManualsBrandsCode 3 ManualsAutomotiveSuperVisor

INSTALLATION

& OPERATION

MANUAL

Read all instructions and warnings before installing and using.

This manual must be delivered to the end user of this equipment.IMPORTANT:

Introduction..........................................................................2

Unpacking & Pre-Installation................................................2

Installation & Mounting ..................................................... 3-5

Wiring Diagram .................................................................... 5

Wiring Instructions & Fusing................................................ 6

LED Flash Pattern Selection & Troubleshooting.................. 7

Exploded View & Parts List .................................................8

Notes .............................................................................. 9-11

Warranty ............................................................................ 12

CONTENTS:

For future reference record your product's serial no. here __________________________________________

INSTALLER:

SuperVisor TL™

Interior Lighting System

Chevrolet Tahoe

2007 Model

SUPERVISOR TL™

Summary of content (12 pages)

PAGE 1
INSTALLATION & OPERATION MANUAL SUPERVISOR TL™ SuperVisor TL™ Interior Lighting System Chevrolet Tahoe 2007 Model CONTENTS: Introduction .......................................................................... 2 Unpacking & Pre-Installation ................................................ 2 Installation & Mounting ..................................................... 3-5 Wiring Diagram .................................................................... 5 Wiring Instructions & Fusing ...................
PAGE 2
Introduction The SuperVisor TL™ is an interior lighting system that fits in the visor area near the top of the windshield. It delivers an amazing warning signal. The SuperVisor TL is designed on a modular basis, which means that the lightbar can be customized to meet most any requirements. The SuperVisor TL has room for up to ten LED lightheads. Each lighthead is individually wired for any flash pattern or combination of flash patterns required.
PAGE 3
WARNING! ! Utilizing non-factory supplied screws and/or mounting brackets and/or the improper number of screws may result in loss of warranty coverage on the equipment. Mounting Hardware - All mounting hardware is packed in a small box inside the main carton. There are four brackets used to mount the Supervisor TL to the vehicle. These are discussed in detail later. Step 1-Removing Sun Visors Begin the installation by removing the driver and passenger sun visors.
PAGE 4
Step 3 Attach the pivot arm brackets Attach the outer mounting brackets that are supplied noting the difference between passenger and driver side brackets (see Figure 10 Note:The Driver side is shown). Rotate the pivot arm on the Driver's side sun visor and verify the orientation of the outer bracket as shown in Figure 11.
PAGE 5
FIGURE 19 FIGURE 20 FIGURE 21 The bracket fasteners make excellent hard mounting points for radar guns and video cameras etc. Caution: Drilling into the housing of the lightbar could damage wiring or other internal components.
PAGE 6
Wiring Instructions ! WARNING! Larger wires and tight connections will provide longer service life for components. For high current wires it is highly recommended that terminal blocks or soldered connections be used with shrink tubing to protect the connections. Do not use insulation displacement connectors (e.g. 3M® Scotchlock type connectors). Route wiring using grommets and sealant when passing through compartment walls. Minimize the number of splices to reduce voltage drop.
PAGE 7
Directional Module Flash Pattern Flash Pattern Cycle Flash Steady-Burn Five Flash Quad Flash Triple Flash Double Flash Fast Double Flash NFPA Quad Pop Flash Triple Pop Flash Description Cycles through various patterns @ 70 fpm Steady-Burn Five Pulses per flash @ 70 fpm Four Pulses per flash @ 70 fpm Three Pulses per flash @ 70 fpm Two Pulses per flash @ 70 fpm Two Pulses per flash @ 85 fpm Four Pulses, 70% Duty Cycle @ 75 fpm Four Pulses per flash ( 3 equal, 1 extended) @ 70 fpm Three Pulses per flash ( 2
PAGE 8
Parts List Reference Number Part Description Part Number 1 *LED Module *Contact Code 3, Inc for P/N 2 Chassis T14720 3 Outer Panel T14721 4 Inner Mtg. Brkt. Tahoe T14719 5 Outer Mtg. Brkt. Tahoe Pass Side T14718 6 Outer Mtg. Brkt.
PAGE 9
Notes 9
PAGE 10
Notes 10
PAGE 11
Notes 11
PAGE 12
WARRANTY Code 3, Inc.'s emergency devices are tested and found to be operational at the time of manufacture. Provided they are installed and operated in accordance with manufacturer's recommendations, Code 3, Inc. guarantees all parts and components except the lamps to a period of 1 year, LED Lighthead modules to a period of 5 years (unless otherwise expressed) from the date of purchase or delivery, whichever is later.