User Manual

Is there no transponder the reader will respond
STX>M<NAK><EOT>
. Setting the number of transponders to be programmed
be set must include the master transponder. The
number of transponders is
ber of transponders to be stored (from 00 to 32 HEX)
STX><ACK><EOT>
er transponder) the number must be set to the
A in HEX. The command shall be:
STX>Z1A<EOT>
5. Reading the number of transponders to be programmed
r of reserved memory for transponders use the command
s with
hexadecimal number of reserved memory for transponder numbers including the master
ansponder.
For using all
5 programmed key transponders you have to set the reserved memory to 26 (1A in HEX).
6. Reading key transponder numbers
sponder numbers stored in the memory with following command
mory location in HEX (from 00 to 32 HEX)
er stored at this location the reader responds with
<STX>FFFFFFFFFF<EOT>
7. Setting the reader modes “Stand-alone” and “Reading head”
de will be set with following command
ode will be set with following command
successful change of mode otherwise with
<STX>NAK<EOT>
8. Enable/Disable the Master transponder
master transponder functionality with following command
ed by using the master transponder.
er transponder functionality again use
successful change of mode otherwise with
<STX>NAK<EOT>
<
4
For programming transponders to the memory of the reader, there must be set the numbers of
transponders to be programmed. The number to
command to set the
<STX>Zxx<EOT>
xx is the hexadecimal num
The reader responds with
<
Example:
If you want to store 25 key transponders (plus the mast
26 decimal which is 1
<
To read the numbe
<STX>Y<EOT>
The reader respond
<STX>xx<EOT>
xx shows the
tr
Attention: If you have programmed for example 25 key transponders into the reader and you set the
number of reserved memory to 10 only the first 9 key transponders will activate the output.
2
You can read the tran
<STX>Gxx<EOT>
xx is the number of the me
The reader responds with
<STX>[Transpondernumber]<EOT>
Is there no transponder numb
The stand alone mo
<STX>K1<EOT>
The reading head m
<STX>K1<EOT>
The reader responds with
<STX>ACK<EOT> after
You can disable the
<STX>J0<EOT>
After this command no more key transponders can be add
To enable the mast
<STX>J1<EOT>
The reader responds with
<STX>ACK<EOT> after
9