User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 NGTtransceiver compliance
- 2 Installation
- 3 The handset
- 4 Getting started
- Switching on the transceiver
- Changing the screen contrast
- Changing the screen brightness
- Using the keys on the handset
- Accessing the Main Menu
- Switching scanning on or off
- Switching mute on or off
- Entering your station self address
- Listen Before Transmit Mode
- Replacing LQA information for all channels in an ALE/CALM network
- Making a manual sounding operation in an ALE/CALM network
- Selecting the best channel in an ALE/CALM network
- Making a Selective call from the Address List
- Making a Phone call from the Address List
- Making an emergency call using the emergency key
- Using a special ALE address syntax to make a call
- Appendix A— Standard hot keys
- Appendix B— Entering and editing text
- Appendix C— Finding words and values
- Appendix D— Creating an entry in a list
- Appendix E— HF radio transmission
- Appendix F— Definitions
- Index
Getting started
NGT ASR Transceiver Getting Started Guide 45
Replacing LQA information as part of a call in an
ALE/CALM network
To replace LQA information as part of a call:
1 Press the key to stop scanning.
1 Start the call using your preferred method.
For example, go to the Address List then select the entry
for the station you want to call.
1 When the transceiver prompts you to select a
channel/mode, select <auto>, then hold the key.
1 View the LQA screen for the best channel/mode to use.
1 Press the key to continue the call.
1 When prompted again to select a channel/mode, you can
either:
• press the key to select the best channel/mode
combination determined during the Channel Test call
• select any other channel that had an acceptable LQA
score
• select <auto> for the transceiver to select the best
channel/mode for the call, starting with the channel on
which the most recent successful link was established
1 Press the key to continue the call.