User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 NGTtransceiver compliance
- 2 Installation
- 3 The handset
- 4 Getting started
- Switching on the transceiver
- Changing the screen contrast
- Changing the screen brightness
- Using the keys on the handset
- Accessing the Main Menu
- Switching scanning on or off
- Switching mute on or off
- Entering your station self address
- Listen Before Transmit Mode
- Replacing LQA information for all channels in an ALE/CALM network
- Making a manual sounding operation in an ALE/CALM network
- Selecting the best channel in an ALE/CALM network
- Making a Selective call from the Address List
- Making a Phone call from the Address List
- Making an emergency call using the emergency key
- Using a special ALE address syntax to make a call
- Appendix A— Standard hot keys
- Appendix B— Entering and editing text
- Appendix C— Finding words and values
- Appendix D— Creating an entry in a list
- Appendix E— HF radio transmission
- Appendix F— Definitions
- Index
Installation
NGT ASR Transceiver Getting Started Guide 15
Mounting the speaker
To mount the speaker:
1 Secure the mounting cradle to the surface with at least
two screws.
Ensure there is sufficient space at the rear for the cable.
1 Attach the speaker to the cradle with the two screws and
rubber washers.
Mounting the junction box
To mount the junction box:
1 Use cable ties or screws to secure the junction box in a
suitable location.
Mounting the RF unit
The cradle can be mounted in any position that allows the RF
unit to be inserted into the cradle.
To mount the RF unit:
1 Secure the mounting cradle to the surface with at least
four screws, one in each corner of the cradle.
1 If the key is locked to the base of the cradle, flip the key
away from the base until it can be rotated (see
Figure 1 on page 13), then rotate the key in a
counterclockwise direction.
WARNING
If you are transferring a fixed station to a mobile
station and you have installed rubber feet to the
bottom of the RF unit, you must remove the
rubber feet before installing it into the mounting
cradle.
NOTE
Ensure there is sufficient space at the rear
of the cradle to clear the RF unit heatsink.