User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 NGTtransceiver compliance
- 2 Installation
- 3 The handset
- 4 Getting started
- Switching on the transceiver
- Changing the screen contrast
- Changing the screen brightness
- Using the keys on the handset
- Accessing the Main Menu
- Switching scanning on or off
- Switching mute on or off
- Entering your station self address
- Listen Before Transmit Mode
- Replacing LQA information for all channels in an ALE/CALM network
- Making a manual sounding operation in an ALE/CALM network
- Selecting the best channel in an ALE/CALM network
- Making a Selective call from the Address List
- Making a Phone call from the Address List
- Making an emergency call using the emergency key
- Using a special ALE address syntax to make a call
- Appendix A— Standard hot keys
- Appendix B— Entering and editing text
- Appendix C— Finding words and values
- Appendix D— Creating an entry in a list
- Appendix E— HF radio transmission
- Appendix F— Definitions
- Index
NGT transceiver compliance
8NGT ASR Transceiver Getting Started Guide
Electrical safety
To ensure compliance with the European Low Voltage
Directive is maintained, you must install and use the
NGT transceiver in accordance with the instructions in the
NGT ASR Transceiver Getting Started Guide and the NGT
ASR Transceiver Reference Manual.
When using equipment that is connected directly to the AC
mains these precautions must be followed and checked before
apply AC power to the unit:
1 Use the standard AC mains cable supplied.
1 Ensure the covers for the equipment are fitted correctly.
Earth symbols
Chassis earth connection points have been provided on the
NGT transceiver and 3020 Transceiver Supply. A protective
earth is provided in the AC mains wiring of the 3020
Transceiver Supply. This protective earth needs to be
connected at the AC mains supply outlet. The symbols shown
in Table 1 are used to identify the earths on the equipment.
CAUTION
If it is necessary to remove the covers at
any stage, they must be refitted correctly
before using the equipment.
WARNING
A protective earth connection must be
included in the mains wiring to the 3020
Transceiver Supply (see page 8, Earth
symbols).
The protective cover must always be fitted
when the 3020 Transceiver Supply is
connected to the AC mains.