User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 NGT transceiver compliance
- 2 Installation
- 3 The handset
- 4 Getting started
- Appendix A- Entering and editing text
- Appendix B- Using Quick Start
- Appendix C- Transceiver specifications
- Appendix D- HF radio transmission
- Appendix E- Definitions
- Index
Installation
NGT SRx Transceiver Getting Started Guide 21
To connect the tuner to the RF unit:
1 Connect the plug at the end of the coaxial cable from the
tuner to the socket at the end of the cable lead from the
RF unit, then secure the locking ring tightly into position.
1 Connect the plug at the end of the control cable from the
tuner to the socket at the end of the cable lead from the
RF unit, then secure the locking ring tightly into position.
1 Connect the antenna to the antenna connector on the
tuner, then secure it tightly into position.
Connecting an antenna selector (optional)
To connect an antenna selector (Codan part number
08-06260-001):
1 Connect the cable from the primary antenna to the ANT1
connector on the antenna selector, then secure the
locking ring tightly into position.
1 Connect the cable from the secondary antenna to the
ANT2 connector on the antenna selector, then secure the
locking ring tightly into position.
1 Connect the plug at the end of the cable lead from the
RF unit to the TCVR connector on the antenna selector,
then secure the locking ring tightly into position.
1 Connect the plug at the end of the control cable from
the RF unit to the corresponding socket on the antenna
selector, then secure the locking ring tightly into
position.
1 If you are using a 9103 Antenna Tuner, connect the plug
at the end of the control cable from the tuner to the
corresponding socket on the antenna selector.
NOTE
If the connectors at the end of the control cables
from the RF unit and tuner are incompatible,
you may require an NGT adaptor cable (Codan
part number 08-05655-001) to connect the tuner
to the RF unit.