User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 NGT transceiver compliance
- 2 Installation
- Mobile stations for NGT AR, SR, AR Voice, and VR Transceivers
- Fixed stations for NGT AR, SR, AR Voice, and VR Transceivers
- 3 The handset
- 4 Getting started
- Appendix A- Entering and editing text
- Appendix B- Using Quick Start
- Appendix C- Using a GPS receiver
- Appendix D- Transceiver specifications
- Appendix E- HF radio transmission
- Appendix F- Definitions
- Index
Installation
22 NGT Transceiver Getting Started Guide
Connecting the power supply
To connect the transceiver to the battery power supply:
1 Connect the power supply cable (Codan part number
08-03255) to the plug at the end of the 12 V cable lead
from the RF unit.
1 Route the power supply cable according to the
instructions supplied with the Vehicle Installation Kit
(Codan part number 15-00112).
1 Insert the 32 A fuse and holder in the power supply cable
at a convenient location, as close as possible to the
battery terminals.
1 Connect the power supply cable to the battery terminals,
black to negative, red to positive.
Connecting ancillary equipment
The NGT AR and SR Transceiver mobile systems use the
junction box for connecting to ancillary equipment.
The 4-way connector on the RF unit of the NGT AR Voice
Transceiver is available for connecting a GPS receiver.