User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 Overview
- 2 Installing the 3160
- Disclaimer
- What you need to consider
- Installing the 3160 in a basic layout
- Installing the 3160 in a stacked layout
- Attaching the 2110 amplifier adaptor panel to the rear of the transceiver cradle
- Attaching the 3160, voltage regulator and external speaker to a mounting surface
- Attaching a suitable power supply to the power supply cover
- Attaching the power amplifier mounting bracket to the transceiver cradle
- Attaching the 3160 and external speaker to the power amplifier mounting bracket
- Connecting the equipment
- Setting up the transceiver
- Grounding the 3160
- Installing the station
- 3 Specifications
- 4 Accessories
- Appendix A- Connectors
- Appendix B- Compliance
- Appendix C- Definitions
- Index
Compliance
52 Power Amplifier 3160 Installation Handbook
IC approval
The 3160 Power Amplifier meets the requirements of
RSS-131.
The following information is relevant for the 3160 Power
Amplifier:
The manufacturer’s rated output power of this equipment is
for single carrier operation. For situations when multiple
carrier signals are present, the rating would have to be reduced
by 3.5 dB, especially where the output signal is re-radiated
and can cause interference to adjacent band users. This power
reduction is to be by means of input power or gain reduction
and not by an attenuator at the output of the device.
Nominal passband gain 10 dB
Nominal bandwidth 28.4 MHz
Rated mean output power 125 W
Input/output impedance 50 Ω