User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 Overview
- 2 Installing the 3160
- Disclaimer
- What you need to consider
- Installing the 3160 in a basic layout
- Installing the 3160 in a stacked layout
- Attaching the 2110 amplifier adaptor panel to the rear of the transceiver cradle
- Attaching the 3160, voltage regulator and external speaker to a mounting surface
- Attaching a suitable power supply to the power supply cover
- Attaching the power amplifier mounting bracket to the transceiver cradle
- Attaching the 3160 and external speaker to the power amplifier mounting bracket
- Connecting the equipment
- Setting up the transceiver
- Grounding the 3160
- Installing the station
- 3 Specifications
- 4 Accessories
- Appendix A- Connectors
- Appendix B- Compliance
- Appendix C- Definitions
- Index
Compliance
48 Power Amplifier 3160 Installation Handbook
EMC
To ensure compliance with the EMC Directive is maintained,
you must:
1 Use the standard shielded cables supplied from Codan
(where applicable).
Electrical safety
To ensure compliance with the European Low Voltage
Directive is maintained, you must install the 3160 Power
Amplifier in accordance with the instructions in this
handbook, and operate the 3160 Power Amplifier in
accordance with the instructions in the relevant Getting
Started Guide and Reference Manual for your transceiver.
C-tick approval
The 3160 Power Amplifier meets the requirements of the
Australian Communications and Media Authority:
Radiocommunications (MF and HF equipment—Land Mobile
Service) Standards 2003 (AS/NZS 4470).