User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 Overview
- 2 Installing the 3160
- Disclaimer
- What you need to consider
- Installing the 3160 in a basic layout
- Installing the 3160 in a stacked layout
- Attaching the 2110 amplifier adaptor panel to the rear of the transceiver cradle
- Attaching the 3160, voltage regulator and external speaker to a mounting surface
- Attaching a suitable power supply to the power supply cover
- Attaching the power amplifier mounting bracket to the transceiver cradle
- Attaching the 3160 and external speaker to the power amplifier mounting bracket
- Connecting the equipment
- Setting up the transceiver
- Grounding the 3160
- Installing the station
- 3 Specifications
- 4 Accessories
- Appendix A- Connectors
- Appendix B- Compliance
- Appendix C- Definitions
- Index
Installing the 3160
Power Amplifier 3160 Installation Handbook 35
Installing the station
To install the 3160 in a mobile or fixed station:
1 Attach the transceiver cradle or the power supply cover
to an appropriate mounting surface according to any
relevant standards and approvals.
1 Connect an earth strap to a convenient location on the
bodywork or earth system for the building using the
25 mm long, self-tapping, pan pozi screw provided.
1 Connect the antenna to the transceiver (see the fitting
instructions provided with the mounting cradle and or
equipment).
1 Protect any cables that pass through metal panels with
rubber grommets.
1 Tape the connectors on the antenna, and approximately
25 mm (1 in) of each cable, with two layers of self-
amalgamating PIB tape (Rotunda 2501) or EPR tape (3M
Scotch™ 23).
1 Cover the self-amalgamating tape with two layers of
high-quality electrical tape (3M Scotch™ 33+, or
similar) to minimise aging of the self-amalgamating tape.
1 Test the installed 3160 (with connected transceiver) as
described in the Reference Manual provided with your
transceiver.
NOTE
In a mobile station, you may need to use a
mounting setup that absorbs vibration.
NOTE
Ensure a good electrical connection is
made.
NOTE
Troubleshooting for a 3160 and how to
install a transceiver are provided in the
Reference Manual.