User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 Overview
- 2 Installing the 3160
- Disclaimer
- What you need to consider
- Installing the 3160 in a basic layout
- Installing the 3160 in a stacked layout
- Attaching the 2110 amplifier adaptor panel to the rear of the transceiver cradle
- Attaching the 3160, voltage regulator and external speaker to a mounting surface
- Attaching a suitable power supply to the power supply cover
- Attaching the power amplifier mounting bracket to the transceiver cradle
- Attaching the 3160 and external speaker to the power amplifier mounting bracket
- Connecting the equipment
- Setting up the transceiver
- Grounding the 3160
- Installing the station
- 3 Specifications
- 4 Accessories
- Appendix A- Connectors
- Appendix B- Compliance
- Appendix C- Definitions
- Index
Installing the 3160
34 Power Amplifier 3160 Installation Handbook
Setting up the transceiver
To set up the transceiver for operation with the 3160:
1 Go to the Cfg Auto Tune Mode entry in the Control List.
1 Do one of the following:
• If the transceiver is installed permanently with the
3160, set the Cfg Auto Tune Mode entry to
50 Ohm.
• If the transceiver is installed for jerk-and-run
capability, set the Cfg Auto Tune Mode entry to
ATU/ 50/ Codan.
1 Switch the transceiver off then on again to activate the
change.
The screen should look similar to the following.
Grounding the 3160
To ground the 3160:
1 Attach one end of the earth wire to the earth terminal ( )
on the connector panel of the 3160.
1 Attach the other end of the earth wire to the earth system
for the station using the 25 mm long, self-tapping, pan
pozi screw provided.
antenna
external power
supply indicator
selection
icon