User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 Overview
- 2 Installing the 3160
- Disclaimer
- What you need to consider
- Installing the 3160 in a basic layout
- Installing the 3160 in a stacked layout
- Attaching the 2110 amplifier adaptor panel to the rear of the transceiver cradle
- Attaching the 3160, voltage regulator and external speaker to a mounting surface
- Attaching a suitable power supply to the power supply cover
- Attaching the power amplifier mounting bracket to the transceiver cradle
- Attaching the 3160 and external speaker to the power amplifier mounting bracket
- Connecting the equipment
- Setting up the transceiver
- Grounding the 3160
- Installing the station
- 3 Specifications
- 4 Accessories
- Appendix A- Connectors
- Appendix B- Compliance
- Appendix C- Definitions
- Index
Installing the 3160
Power Amplifier 3160 Installation Handbook 33
Connecting the equipment
The equipment is connected the same, regardless of the layout
that is used. The length of each cable used may vary
depending on the layout. See Figure 5 on page 10 and
Figure 6 on page 12 for more information.
To connect the equipment:
1 Connect the 12-way connector on the power adaptor
cable (08-06808-xxx) to the 12 V connector on the 3160.
1 Connect the 6-way connector on the power adaptor cable
to the connector on the 2110 amplifier adaptor panel.
1 Connect the BNC–BNC coaxial cable (08-06809-xxx)
between the connector on the front panel of the
transceiver and the RF INPUT connector on the 3160.
1 Connect the 12 V connector on the power adaptor cable
to a suitable 12 V DC supply (see page 6, Power supply
options).
1 Connect a coaxial cable between the connector on the
3160 and the appropriate connector on the antenna.
1 Connect the antenna control cable between the lead
from the interface adaptor and the appropriate connector
on the antenna or antenna tuner, if required.