User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 Overview
- 2 Installing the 3160
- Disclaimer
- What you need to consider
- Installing the 3160 in a basic layout
- Installing the 3160 in a stacked layout
- Attaching the 2110 amplifier adaptor panel to the rear of the transceiver cradle
- Attaching the 3160, voltage regulator and external speaker to a mounting surface
- Attaching a suitable power supply to the power supply cover
- Attaching the power amplifier mounting bracket to the transceiver cradle
- Attaching the 3160 and external speaker to the power amplifier mounting bracket
- Connecting the equipment
- Setting up the transceiver
- Grounding the 3160
- Installing the station
- 3 Specifications
- 4 Accessories
- Appendix A- Connectors
- Appendix B- Compliance
- Appendix C- Definitions
- Index
Installing the 3160
32 Power Amplifier 3160 Installation Handbook
Figure 13: 3160 and power amplifier mounting bracket
1 Attach the 3160 to the bracket using an M5 × 20 mm
long, black, stainless steel, pan pozi screw through each
hole in the flanges of the 3160 into the captive nut in the
bracket.
1 Attach the mounting cradle of the speaker to the power
amplifier mounting bracket using an M4 × 6 mm long,
stainless steel, pan pozi screw through each hole in the
cradle into the captive nut in the bracket.
1 Attach the speaker to the mounting cradle with the two
thumb screws and rubber washers provided.