User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 Overview
- 2 Installing the 3160
- Disclaimer
- What you need to consider
- Installing the 3160 in a basic layout
- Installing the 3160 in a stacked layout
- Attaching the 2110 amplifier adaptor panel to the rear of the transceiver cradle
- Attaching the 3160, voltage regulator and external speaker to a mounting surface
- Attaching a suitable power supply to the power supply cover
- Attaching the power amplifier mounting bracket to the transceiver cradle
- Attaching the 3160 and external speaker to the power amplifier mounting bracket
- Connecting the equipment
- Setting up the transceiver
- Grounding the 3160
- Installing the station
- 3 Specifications
- 4 Accessories
- Appendix A- Connectors
- Appendix B- Compliance
- Appendix C- Definitions
- Index
Installing the 3160
Power Amplifier 3160 Installation Handbook 29
Figure 11: Power supply cover, cradle, power amplifier
mounting bracket, interface adaptor, and coaxial cable
1 Align the holes in the flanges of the interface adaptor
with the holes in the power amplifier mounting bracket
and the cradle.
1 Insert an M4 × 12 mm long, black, stainless steel, pan
pozi screw into each of the holes for the interface adaptor
and power amplifier mounting bracket, then screw these
one turn into the transceiver cradle.
1 On the other side of the cradle, insert an M4 × 12 mm
long, black, stainless steel, pan pozi screw into each of
the P-clips, passing these through the power amplifier
mounting bracket into the transceiver cradle.
NOTE
Lift the mounting bracket to align the holes
with those on the transceiver cradle.