User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 Overview
- 2 Installing the 3160
- Disclaimer
- What you need to consider
- Installing the 3160 in a basic layout
- Installing the 3160 in a stacked layout
- Attaching the 2110 amplifier adaptor panel to the rear of the transceiver cradle
- Attaching the 3160, voltage regulator and external speaker to a mounting surface
- Attaching a suitable power supply to the power supply cover
- Attaching the power amplifier mounting bracket to the transceiver cradle
- Attaching the 3160 and external speaker to the power amplifier mounting bracket
- Connecting the equipment
- Setting up the transceiver
- Grounding the 3160
- Installing the station
- 3 Specifications
- 4 Accessories
- Appendix A- Connectors
- Appendix B- Compliance
- Appendix C- Definitions
- Index
Installing the 3160
26 Power Amplifier 3160 Installation Handbook
Attaching the 3160, voltage regulator and
external speaker to a mounting surface
To attach the 3160, voltage regulator, and speaker to a
mounting surface:
1 Position the 3160 on a suitable mounting surface with the
fins either facing upwards or running vertically, and the
connectors easily accessible.
1 Do one of the following:
• Attach the 3160 to the mounting surface using a
12AB × 25 mm long, self-tapping, pan pozi screw in
each of the holes in the flanges of the 3160.
• Attach the 3160 to the mounting structure using an
M6 × 25 mm long, stainless steel Hex screw with an
M6 stainless steel spring washer, and M6 stainless steel
hex nut in each of the holes in the flanges of the 3160.
1 Attach the voltage regulator to a suitable mounting
surface using appropriate screws, washers, and nuts as
required.
1 Attach the mounting cradle of the speaker to the
mounting surface with appropriate screws, washers, and
nuts as required.
1 Attach the speaker to the mounting cradle with the two
thumb screws and rubber washers provided.
1 Continue from page 33, Connecting the equipment.