User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 Overview
- 2 Installing the 3160
- Disclaimer
- What you need to consider
- Installing the 3160 in a basic layout
- Installing the 3160 in a stacked layout
- Attaching the 2110 amplifier adaptor panel to the rear of the transceiver cradle
- Attaching the 3160, voltage regulator and external speaker to a mounting surface
- Attaching a suitable power supply to the power supply cover
- Attaching the power amplifier mounting bracket to the transceiver cradle
- Attaching the 3160 and external speaker to the power amplifier mounting bracket
- Connecting the equipment
- Setting up the transceiver
- Grounding the 3160
- Installing the station
- 3 Specifications
- 4 Accessories
- Appendix A- Connectors
- Appendix B- Compliance
- Appendix C- Definitions
- Index
Installing the 3160
24 Power Amplifier 3160 Installation Handbook
Attaching the 2110 amplifier adaptor panel
to the rear of the transceiver cradle
To attach the panel to the cradle:
1 Place the cradle with the mounting domes facing down.
1 Position the 2110 amplifier adaptor panel as shown in
Figure 9.
Figure 9: 2110 amplifier adaptor panel and cradle
1 Attach the 2110 amplifier adaptor panel to the rear of the
cradle using the four M3 × 12 mm long, black, stainless
steel, pan pozi screws provided.
NOTE
If you are mounting the cradle in a basic
layout, orientate the cradle so that it meets
your requirements.
cradle with mounting
domes facing down
2110 amplifier
adaptor panel