User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 Overview
- 2 Installing the 3160
- Disclaimer
- What you need to consider
- Installing the 3160 in a basic layout
- Installing the 3160 in a stacked layout
- Attaching the 2110 amplifier adaptor panel to the rear of the transceiver cradle
- Attaching the 3160, voltage regulator and external speaker to a mounting surface
- Attaching a suitable power supply to the power supply cover
- Attaching the power amplifier mounting bracket to the transceiver cradle
- Attaching the 3160 and external speaker to the power amplifier mounting bracket
- Connecting the equipment
- Setting up the transceiver
- Grounding the 3160
- Installing the station
- 3 Specifications
- 4 Accessories
- Appendix A- Connectors
- Appendix B- Compliance
- Appendix C- Definitions
- Index
Installing the 3160
22 Power Amplifier 3160 Installation Handbook
Installing the 3160 in a stacked layout
The stacked layout uses a power amplifier mounting bracket
to attach the 3160 and external speaker to the transceiver
cradle. For more information see Figure 6 on page 12.
NOTE
The rear of the transceiver cradle and the 3160
must be within 2 m of each other.
WARNING
If this layout is installed in a mobile station, all
items must be attached to appropriate mounting
surfaces according to the relevant standards and
approvals.
NOTE
The power supply cover is not required if the
3160 is connected directly to a 12 V DC battery.