User's Manual

Installing the 3160
Power Amplifier 3160 Installation Handbook 21
Installing the 3160 in a basic layout
The basic layout uses the transceiver cradle and 2110
amplifier adaptor panel, but does not use any mounting
brackets. For more information see Figure 5 on page 10.
Figure 7: Process for installing the 3160 in a basic
layout
Attach the 2110 amplifier adaptor panel and
interface adaptor to the transceiver cradle
Attach the transceiver cradle to
an appropriate mounting surface
Insert the transceiver into the cradle,
then lock in place
Attach the 3160, voltage regulator (if used), and
external speaker to appropriate mounting surfaces
Connect the 2110 amplifier adaptor panel,
3160, and power supply together
Connect the interface adaptor to the transceiver
Connect the RF and control cables between the
transceiver, 3160, and antenna as required
Connect the external speaker to the interface adaptor
Ground the 3160
See page 24, Attaching the 2110
amplifier adaptor panel to the rear
of the transceiver cradle and the
fitting instruction provided with the
cradle
See page 26, Attaching the 3160,
voltage regulator and external
speaker to a mounting surface
See page 33, Connecting the
equipment
See page 34, Grounding the 3160