User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 Overview
- 2 Installing the 3160
- Disclaimer
- What you need to consider
- Installing the 3160 in a basic layout
- Installing the 3160 in a stacked layout
- Attaching the 2110 amplifier adaptor panel to the rear of the transceiver cradle
- Attaching the 3160, voltage regulator and external speaker to a mounting surface
- Attaching a suitable power supply to the power supply cover
- Attaching the power amplifier mounting bracket to the transceiver cradle
- Attaching the 3160 and external speaker to the power amplifier mounting bracket
- Connecting the equipment
- Setting up the transceiver
- Grounding the 3160
- Installing the station
- 3 Specifications
- 4 Accessories
- Appendix A- Connectors
- Appendix B- Compliance
- Appendix C- Definitions
- Index
Installing the 3160
20 Power Amplifier 3160 Installation Handbook
Fixed station
There are no specific requirements for locating the transceiver
and 3160 in a fixed station.
Mounting
The installed 3160 should enable easy access to the
connectors. The 3160 should be positioned with the fins on the
heatsink pointing upwards (as in the stacked layout), or if
mounted on a vertical surface, with the fins on the heatsink
running vertically (see Figure 5 on page 10).
In a mobile station, attach all items of the 3160 system to
structural components of the vehicle.
Grounding
The 3160 Power Amplifier must be grounded using an earth
strap (08-04515-001). In a mobile station, this strap must be
connected to the vehicle chassis. For more information see
page 34, Grounding the 3160.
WARNING
Do not attach any items to loose or plastic
panels in a vehicle.