User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 Overview
- 2 Installing the 3160
- Disclaimer
- What you need to consider
- Installing the 3160 in a basic layout
- Installing the 3160 in a stacked layout
- Attaching the 2110 amplifier adaptor panel to the rear of the transceiver cradle
- Attaching the 3160, voltage regulator and external speaker to a mounting surface
- Attaching a suitable power supply to the power supply cover
- Attaching the power amplifier mounting bracket to the transceiver cradle
- Attaching the 3160 and external speaker to the power amplifier mounting bracket
- Connecting the equipment
- Setting up the transceiver
- Grounding the 3160
- Installing the station
- 3 Specifications
- 4 Accessories
- Appendix A- Connectors
- Appendix B- Compliance
- Appendix C- Definitions
- Index
Overview
14 Power Amplifier 3160 Installation Handbook
Compatibility
The following hardware build standards are required for
operation with the 3160:
Both types of transceiver must have firmware V4.91 or later.
Upgrades are available for the hardware and firmware. Please
contact your Codan representative for more information.
Transceiver type Build standard
2110M Manpack Transceiver A or later
2110 Manpack Transceiver H or later
NOTE
The build standard is indicated by the 8th
character in the serial number of the transceiver.
The serial number is located under the bar code.