User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 Overview
- 2 Installing the 3160
- Disclaimer
- What you need to consider
- Installing the 3160 in a basic layout
- Installing the 3160 in a stacked layout
- Attaching the 2110 amplifier adaptor panel to the rear of the transceiver cradle
- Attaching the 3160, voltage regulator and external speaker to a mounting surface
- Attaching a suitable power supply to the power supply cover
- Attaching the power amplifier mounting bracket to the transceiver cradle
- Attaching the 3160 and external speaker to the power amplifier mounting bracket
- Connecting the equipment
- Setting up the transceiver
- Grounding the 3160
- Installing the station
- 3 Specifications
- 4 Accessories
- Appendix A- Connectors
- Appendix B- Compliance
- Appendix C- Definitions
- Index
Overview
6 Power Amplifier 3160 Installation Handbook
Power supply options
The 3160 Power Amplifier requires a 12 V DC supply. This
may be supplied by one of the following sources:
• 3020 Transceiver Supply (fixed station only; this
requires connection to the AC mains supply)
• 12 V DC vehicle battery (see Figure 3 on page 7)
• 24 V DC vehicle battery via a 24 V to 12 V voltage
regulator (see Figure 4 on page 7)
Figure 2: Power supply from a 3020 Transceiver
Supply
NOTE
You can mount the 3020 Transceiver Supply or
the voltage regulator within a power supply
cover (Codan part number 15-00147).
earth strap
08-04515
3020 Transceiver Supply
AC
power adaptor cable
08-06808-xxx