User's Manual
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 Overview
- 2 Installing the 3160
- Disclaimer
- What you need to consider
- Installing the 3160 in a basic layout
- Installing the 3160 in a stacked layout
- Attaching the 2110 amplifier adaptor panel to the rear of the transceiver cradle
- Attaching the 3160, voltage regulator and external speaker to a mounting surface
- Attaching a suitable power supply to the power supply cover
- Attaching the power amplifier mounting bracket to the transceiver cradle
- Attaching the 3160 and external speaker to the power amplifier mounting bracket
- Connecting the equipment
- Setting up the transceiver
- Grounding the 3160
- Installing the station
- 3 Specifications
- 4 Accessories
- Appendix A- Connectors
- Appendix B- Compliance
- Appendix C- Definitions
- Index
Overview
4 Power Amplifier 3160 Installation Handbook
General
The 3160 Power Amplifier is designed to provide 125 W
transmitting power for a 2110M or 2110 Manpack
Transceiver. The 3160 provides 12 V DC to the transceiver
from a suitable power source. When the 3160 is connected
into the transceiver system, it is automatically detected when
the transceiver is switched on.
Figure 1: 3160 Power Amplifier
NOTE A 100 W option is available.
NOTE
For information on hardware and software
compatibility requirements see page 14,
Compatibility.
3160 Power Amplifier
Serial No.Serial No.Serial No.Serial No.Serial No.
N101N101N101N101N101