Operator's Guide
Table Of Contents
- _
- _
- Table of Contents
- Charging and installing batteries
- Attaching a ground wire to the radio
- Inserting a 6110-MP into a backpack
- Selecting and connecting your antenna
- Testing your radio before deployment
- Front panel and screen overview
- Handsets
- Speaker and mute
- Discreet mode and zeroise
- Secure communications
- Entering and editing text
- Scanning, channel and scratch modes
- HF networks
- Call types
- Answering and ending a call
- Making a 2G or 3G ALE call
- Making a Selcall call
- Stations
- Viewing GPS Information
- Update the radio profile with a USB thumb drive
- Troubleshooting
- Definitions
- Menu Navigation
- _
Viewing GPS Information
Obtaining your position
The GPS screen shows the GPS information obatined from a GPS receiver or latitude and
longitude readings from a GPS receiver, or from Settings > GPS > My Position. Altitude and
speed readings are hidden by default. The spinning circle shows that the GPS receiver is active,
and the Last Fix reading shows the time lapse from the last receipt of valid GPS information.
Note: The format of information on the GPS screen is defined by the Settings > GPS >
GPS Format Options setting.
To view GPS information do one of the following:
• Press the key; or
• From the main menu, select (General), then (GPS).
Note: The Sentry-H 6110-MP radio uses two Global Navigation Satellite Systems
(GNSS) to calculate position information with improved accuracy and reduced time for
signal acquisition.
Viewing GPS Information
Page 52 Sentry-H 6110-MP Operator Guide