User's Manual

OPERATING THE TRANSCEIVER
THE CHANNEL SCREEN
58 ENVOY™ TRANSCEIVER REFERENCE MANUAL
Table 2: Information that may be shown in the status areas on the screen
Item Description
Transceiver type Read from the template in the transceiver, for example, X1 or X2
User-defined text 1/2 Any text that you want to show on the screen
Altitude, Latitude, Longitude,
Speed
Derived from GPS signals from a GPS receiver
PA temperature Temperature of the heatsink
Tx power Monitored transmit power from the transceiver
Rx level Strength of an incoming signal shown in dBȝV
Voltage Battery voltage
Last received call Who and when details of the last call received
SWR The ratio of forward to reflected power of the antenna during
transmit (typical reading 1:1.6, which is only valid on the current
channel)
Date, Time, Time Zone Current date, time and time zone of the control point
Package version, Package build
date
Details of the firmware in the transceiver (control point and RFU)
Profile name Name of the TPS profile programmed into the transceiver
Primary self address Self address of the first-listed HF network in your transceiver
Last received address Contact name or address of the last call received
Last sent self address Self address of your transceiver that was sent with the last call that
you made
CP IP address, RFU IP address IP address of the control point or RFU
Power down time Time at which the transceiver will power down, in 24-hour format
Best LQA channel Result of the most recent Channel Test call in an ALE/CALM HF
network
Crosspatch state Current crosspatch state may be XP:
Off|Active|Standby|Disconnected
3012s throughput Grey LED: modem is not in a link
Green LED: modem is in a link and received the link
Red LED: modem is in a link and started the link
Green bar is indicative of the data throughput rate for the link