User's Manual

USING THE WIZARD

18 ENVOY™ TRANSCEIVER REFERENCE MANUAL

 Do one of the following:

• If you want to connect an accessory to the 15-way port of the RFU,

press (Yes), then continue from Selecting a peripheral device on

page 18.

• If you do not want to connect an accessory, press (No), then

press OK to close the wizard.

Selecting a peripheral device

When you select the peripheral device from the list, the transceiver automatically sets

these properties.

NOTE: Codan peripheral devices are listed by their type number, for example,

3031 Crosspatch. The type number for a Codan device is located on the

front or serial number escutcheon.

To select a peripheral device:

 Press or to scroll to the type of peripheral device that is attached to the

connector, then press OK.

If there are settings that you can change to optimise this peripheral for your

requirements, is shown to the right of the peripheral name when it is selected.

 If you want to change settings for the peripheral, press to see the list of entries

that you may change.

If you change the value of an entry for a peripheral device from the default

value, is shown next to the title of the entry.

 Press (Save) to automatically update settings for correct operation of the

connected peripheral device.

 Press OK to close the wizard.

 If you added a peripheral device, restart your transceiver to activate the new

settings.