User's Manual

USING THE WIZARD

ENVOY™ TRANSCEIVER REFERENCE MANUAL 13

Adding a contact

A contact is a person who you want to call, and for whom you want to pre-define the

method of calling them. You may be able to contact the same person via a number of

different methods. When you set up the contact, you define each method as a separate

call for the contact.

NOTE: If you require more detail on adding a contact, see Contacts on

page 143.

To add a contact:

 Enter the name that you want to use for the contact, then press (Add Call).

The HF Network entry is highlighted.

The HF network defines the call system and self address that is used by your

station when the call is made. For example, if you want to select a channel for

the call, use a Selcall HF network. If you want the transceiver to automatically

select a channel for the call, use a CALM HF network.

 Press or to select the HF network that you want to use.

 Press to move to the Call Type entry.

 Press or to select the call type that you want to use.

NOTE: The call type that you select affects information that you can

enter for the remainder of this call.

 If you are adding:

• a Selective, Channel Test, Emergency, Get Position or Send Position call

Adding a simple call on page 14

• a Message call Adding a Message call on page 14

• a Phone call Adding a Phone call on page 16

• a Get Status call Adding a Get Status call on page 16