User's Manual

USING THE WIZARD

12 ENVOY™ TRANSCEIVER REFERENCE MANUAL

Adding channels to a scan table

To add channels to a scan table:

 Press or to scroll to the channel that you want to add, then press OK.

 Press or to select the mode that you want to use.

 Select more channels, as required.

 Press (Save) to add these channel selections.

 Continue from Entering a self address on page 12.

Entering a self address

A self address is used by other stations to call your station. For example, if the self

address of your station is 1234, operators at other stations enter the address 1234 when

they want to make a call to you.

To enter a self address:

 Enter the address that you want to use.

You can enter up to six digits.

NOTE: Addresses ending in 99 and 00 have a special function in Selcall

HF networks.

 Press (Save) to save the information.

NOTE: The wizard automatically allocates this self address to the default

HF networks: Selcall and CALM (if FED-STD-1045 ALE or

MIL-STD-188-141B ALE option is installed).

 Do one of the following:

• If you want to add a contact, press (Yes), then continue from Adding

a contact on page 13.

• If you do not want to add a contact, press (No), then continue from

Selecting an antenna on page 17.