User's Manual

USING THE WIZARD

ENVOY™ TRANSCEIVER REFERENCE MANUAL 11

 Press to move to the Mode entry.

 To select a mode:

• Press to view the list of available modes.

• Press or to scroll to the mode that you want to use, then press OK.

The check box contains a when the mode is selected.

• Select other modes, as required.

NOTE: The modes that you select become the allowed modes for

this channel. In a scan table, you can duplicate a channel

and select another of the allowed modes.

•Press (Save).

 If you want to review the information that you have entered, press or to

move through the entries.

 Press (Save) to save the information.

 Do one of the following:

• If you want to add another channel, press (Yes), then repeat these

steps.

• If you do not want to add another channel, press (No).

The channels that you enter may be notionally grouped into scan tables. A scan

table enables you to manage how these channels are scanned using one set of

properties. The same channel may be included in one or more scan tables. One

or more scan tables may be allocated to an HF network. The same scan table

may be allocated to different HF networks.

 Do one of the following:

• If you want to add a scan table, press (Yes).

• If you do not want to add a scan table, press (No), then continue from

Entering a self address on page 12.

 Do one of the following:

• If you want to scan all of the channels in the transceiver that have a USB

mode, press (Yes), then continue from Entering a self address on

page 12.

• If you want to choose the channels and modes that you want to scan,

press (No), then continue from Adding channels to a scan table on

page 12.