User's Manual

SETTINGS
SETTINGS > CONFIGURATION > GENERAL
ENVOY™ TRANSCEIVER REFERENCE MANUAL 205
Easitalk Start State
The Easitalk Start State entry sets the state of Easitalk at power up.
If you want the transceiver to:
• return to the state it was in prior to the transceiver being switched off then on
again, select Leave as is
• never use Easitalk™ at power up, select Disabled
• always use Easitalk™ at power up, select Enabled
Default value: Leave as is
Default Selcall
The Default Selcall entry sets the default Selcall call system when adding HF
networks.
Available values: Codan, Open
Default value: Codan
Handset AGC
The Handset AGC entry sets the rate of action of AGC for the input signal to the
handset.
To optimise AGC for:
• voice signals, select Slow
• special modes and morse code in a noisy environment, select Fast
• voice and linear data signals, select Hold
Default value: Hold
Handset PTT Beep
The Handset PTT Beep entry sets whether or not astrotones are transmitted when
the PTT button is released during a call. This saves you having to say ‘over’ each time
you release PTT.
Default value: Enabled