User's Manual

SETTINGS
SETTINGS > CONTROL POINT > GENERAL
194 ENVOY™ TRANSCEIVER REFERENCE MANUAL
Show Channel Frequency
The Show Channel Frequency entry sets whether or not frequencies are shown
on the channel screen.
To show:
• both the transmit and receive frequencies, select All
• no frequencies, select None
Default value: All
Frequency Format
The Frequency Format entry sets the format in which frequencies are shown on the
screen. These values change the number of decimal points that are shown.
If you want to show the frequency to:
• one decimal point, select Show 100 Hz
• two decimal points, select Show 10 Hz
• three decimal points, select Show 1 Hz
Default value: Show 100 Hz
CAUTION: If a frequency is entered to the nearest 1 Hz, but the frequency format
is set to show the frequency on the screen to the nearest 100 Hz,
rounding will occur.
NOTE: If you need to know the exact frequency of a channel, you can view this
in User Data > Channels, then select the specific channel.
Call Key Options
The Call Key Options entry sets the default action that occurs when the CALL key
is pressed on the control point. The screen that is not set as the default action is
accessed using hold CALL.
If you want a press of the CALL key to:
• go to the Call screen, select Show Call Screen
• go to the Contacts screen, select Show Contacts Screen
Default value: Show Call Screen
Night Display Brightness
The Night Display Brightness entry sets the brightness of the LCD and keypad
backlight during night-time activity.
Available values: Leave as is, Low, Medium, High
Default value: Low