User's Manual

PERIPHERALS
ENTRIES FOR A PERIPHERAL
ENVOY™ TRANSCEIVER REFERENCE MANUAL 185
Entries for a peripheral
Related links:
RFU 15way Mode on page 185
RFU 15way Speed on page 185
RFU 15way Startup on page 186
RFU Average ALC on page 186
RFU ALC Rate on page 186
RFU Audio Type on page 186
RFU AGC on page 187
RFU PTT Beep on page 187
RFU Rx Out Audio Level on page 187
RFU Mute Extend on page 187
RFU Mute Off After PTT on page 188
RFU Sidetone Volume on page 188
RFU Mute Out Options on page 188
RFU 6way Mode on page 188
RFU 6way Speed on page 189
RFU 6way Startup on page 189
RFU 15way Mode
The RFU 15way Mode entry sets the mode in which the RS232 15-way serial port
operates. This entry is only available if you are setting up the 15-way connector on the
RFU for a user-defined peripheral device.
If the port is:
• not in use, select None
• receiving GPS information, select GPS
• controlling and monitoring the transceiver, select CICS
• connected to a modem, select Data
• connected to a radio/telephone interconnect unit, select 3033
Default value: None
RFU 15way Speed
The RFU 15way Speed entry sets the data rate of the RS232 15-way serial port. If
available, you should set this to the same speed that is set in the connected peripheral
device.
Default value: 9600 bit/s