User's Manual

CHANNELS
WORKING WITH CHANNELS
116 ENVOY™ TRANSCEIVER REFERENCE MANUAL
 Press to move to the Tx entry.
 Enter the transmit frequency (in kHz) that you want to use for this channel.
 Press to move to the Rx entry.
The Rx entry is automatically filled with the transmit frequency.
 Enter the receive frequency (in kHz), if required to be different from the Tx
frequency.
 Press to move to the Mode entry.
 To select a mode:
• Press to view the list of available modes.
• Press or to scroll to the mode that you want to use, then press OK.
The check box contains a when the mode is selected.
• Select other modes, as required.
NOTE: The modes that you select become the allowed modes for
this channel. In a scan table, you can duplicate a channel
and select another of the allowed modes.
• Press (Save).
 Press to move to the Preferred Mode entry.
 Press or to select the mode that you want to use.
 Press to move to the Power entry.
 Press or to select the value that you want to use from the following:
• To transmit at the power level set in the Tx Power entry, select Leave as
is.
• To transmit signals at the value set for the low power range, select Low.
• To transmit signals at the value set for the medium power range, select
Medium.
• To transmit signals at the value set for the high power range, select High.
 If you want to review the information that you have entered, press or to
move through the entries.
 Press (Save) to save the information.