User's Manual

OPERATING THE TRANSCEIVER
CALLING
84 ENVOY™ TRANSCEIVER REFERENCE MANUAL
 If prompted, press or to scroll to the channel that you want to use, then
press CALL.
A is shown next to the currently selected channel/mode.
To abort the call before it is answered, press PTT or SCAN.
There will be audible beeps or a pop-up message to indicate that the call has
been successful.
NOTE: The format of GPS information in call pop-ups, Call Log and Call
History is DDMM.SSSS S, DDDMM.SSSS E, for example,
3452.82 S, 13841.26 E.
Related links:
Get Position call on page 402
Entering text in a field on page 40
Respond GPS on page 218
Privacy mode on page 136
Making a Get Status call
If you want to obtain information on the status of a transceiver at a specific station,
such as the power output of the transmitter or the firmware versions installed, make a
Get Status call to that station. Get Status calls are automatically answered by the
receiving station so an operator is not required to process the return call.
NOTE: The success of your Get Status call depends upon the value set in
Calling > General > Respond OTA of the transceiver you are
calling and the privacy mode of the HF network that you are using for
the call.
To make a Get Status call:
 Press CALL.
The call type and address of the last call are shown at the top of the call screen.