User's Manual

USING THE WIZARD

30 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE

Selecting a peripheral device

When you select the peripheral device from the list, the transceiver

automatically sets these properties.

NOTE: Codan peripheral devices are listed by their type

number, for example, 3031 Crosspatch. The type

number for a Codan device is located on the front or

serial number escutcheon.

To select a peripheral device:

 Press or to scroll to the type of peripheral device that

is attached to the connector, then press OK.

If there are settings that you can change to optimise this

peripheral for your requirements, is shown to the right of

the peripheral name when it is selected.

 If you want to change settings for the peripheral, press to

see the list of entries that you may change.

If you change the value of an entry for a peripheral device

from the default value, is shown next to the title of the

entry.

 Press (Save) to automatically update settings for

correct operation of the connected peripheral device.

 Press OK to close the wizard.

 If you added a peripheral device, restart your transceiver to

activate the new settings.