User's Manual

USING THE WIZARD
USING THE WIZARD
22 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
Adding a contact
A contact is a person who you want to call, and for whom you want
to pre-define the method of calling them. You may be able to
contact the same person via a number of different methods. When
you set up the contact, you define each method as a separate call for
the contact.
NOTE: If you require more detail on adding a contact, see
Contacts on page 93.
To add a contact:
 Enter the name that you want to use for the contact, then
press (Add Call).
The HF Network entry is highlighted.
The HF network defines the call system and self address that
is used by your station when the call is made. For example,
if you want to select a channel for the call, use a Selcall HF
network. If you want the transceiver to automatically select
a channel for the call, use a CALM HF network.
 Press or to select the HF network that you want to use.
 Press to move to the Call Type entry.
 Press or to select the call type that you want to use.
NOTE: The call type that you select affects
information that you can enter for the
remainder of this call.
 If you are adding:
• a Selective, Channel Test, Emergency, Get Position
or Send Position call Adding a simple call on page 23
• a Message call Adding a Message call on page 24
• a Phone call Adding a Phone call on page 26
• a Get Status call Adding a Get Status call on page 27