User's Manual

USING THE WIZARD

20 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE

 Do one of the following:

• If you want to add another channel, press

(Yes), then repeat these steps.

• If you do not want to add another channel,

press (No).

The channels that you enter may be notionally grouped into

scan tables. A scan table enables you to manage how these

channels are scanned using one set of properties. The same

channel may be included in one or more scan tables. One or

more scan tables may be allocated to an HF network. The

same scan table may be allocated to different HF networks.

 Do one of the following:

• If you want to add a scan table, press (Yes).

• If you do not want to add a scan table, press

(No), then continue from Entering a self address on

page 21.

 Do one of the following:

• If you want to scan all of the channels in the

transceiver that have a USB mode, press

(Yes), then continue from Entering a self address on

page 21.

• If you want to choose the channels and modes that

you want to scan, press (No), then continue

from Adding channels to a scan table on page 20.

Adding channels to a scan table

To add channels to a scan table:

 Press or to scroll to the channel that you want to add,

then press OK.

 Press or to select the mode that you want to use.

 Select more channels, as required.