User's Manual

USING THE WIZARD

ENVOY™ TRANSCEIVER GETTING STARTED GUIDE 19

Adding a channel

NOTE: This step in the wizard is shown if you are permitted

to add channels.

To add a channel:

 Press (Yes) to add a channel, if required.

 Enter the name that you want to use for the channel.

 Press to move to the Tx entry.

 Enter the transmit frequency (in kHz) that you want to use

for this channel.

 Press to move to the Rx entry.

The Rx entry is automatically filled with the transmit

frequency.

 Enter the receive frequency (in kHz), if required to be

different from the Tx frequency.

 Press to move to the Mode entry.

 To select a mode:

• Press to view the list of available modes.

• Press or to scroll to the mode that you want to

use, then press OK.

The check box contains a when the mode is

selected.

• Select other modes, as required.

NOTE: The modes that you select become the

allowed modes for this channel. In a

scan table, you can duplicate a channel

and select another of the allowed

modes.

•Press (Save).

 If you want to review the information that you have entered,

press or to move through the entries.

 Press (Save) to save the information.