User's Manual

INSTALLING THE TRANSCEIVER
OVERVIEW OF FIXED STATIONS
ENVOY™ TRANSCEIVER GETTING STARTED GUIDE 117
Rack-mounting unit
A rack-mounting unit consists of a 19 inch rack tray. It can be used
to mount your fixed station with either a desk console or the
handset and cradle.
Connecting a fixed Envoy™ station
NOTE: A typical fixed station is shown in Figure 28.
To connect a fixed station:
 Do one of the following:
• Connect cable 08-07205-00x between the
Transceiver connector on the 2230 Desk Console
and the 10-way plug on the flying lead from the
RFU, securing the locking rings tightly into position.
• Connect cable 08-07215-001 between the Ethernet
connector on the 2230 Desk Console, or an optional
switch/router, and the 10-way plug on the flying lead
from the RFU, securing the locking ring tightly into
position.
•If a switch/router is used, an additional RJ45 cable
is required to connect between the
switch/router and the desk console.
• Connect the lead from the handset and speaker
connector to the 10-way plug on the flying lead from
the RFU, then secure the locking ring tightly into
position.
 If you are using the handset and speaker connector and
cable:
• Connect the plug of the handset cable to the socket
on the handset and speaker connector, then secure
the locking ring tightly into position.
• Connect the plug at the end of the speaker cable to
the socket on the handset and speaker connector,
then secure the cable by pushing it into the slot on the
side of the connector.