User's Manual

INSTALLING THE TRANSCEIVER
OVERVIEW OF MOBILE STATIONS
112 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
Connecting a mobile Envoy™ station
NOTE: A typical mobile station is shown in Figure 27.
To connect a mobile station:
 Connect the cable (Codan part number 08-06022-001) from
the handset and speaker connector to the 10-way plug on the
cable lead from the RFU, then secure the locking ring
tightly into position.
 Connect the plug of the handset cable to the socket on the
handset and speaker connector, then secure the locking ring
tightly into position.
 Connect the plug at the end of the speaker cable to the
socket on the handset and speaker connector, then secure the
cable by pushing it into the slot on the side of the connector.
 Connect the plug at the end of the cable (Codan part
number 08-01503-00x) to the socket at the end of the cable
lead from the RFU, then secure the locking ring tightly into
position.
 Connect the plug at the opposite end of the cable (Codan
part number 08-01503-00x) to the socket located at the base
of the antenna, then secure the locking ring tightly into
position.
Connecting the control cable to an automatic tuning antenna
To connect the control cable to an antenna:
 Connect the socket at the end of the cable (Codan part
number 08-05627-00x) into the plug at the base of the
antenna, then secure the locking ring tightly into position.
 Fit the plug at the opposite end of the cable (Codan part
number 08-05627-00x) into the socket at the end of the
lead from the RFU.