User's Manual

INSTALLING THE TRANSCEIVER
OVERVIEW OF MOBILE STATIONS
ENVOY™ TRANSCEIVER GETTING STARTED GUIDE 111
Mounting the speaker
To mount the speaker:
 Secure the mounting cradle to the surface with at least two
screws.
Ensure there is sufficient space at the rear for the cable.
 Attach the speaker to the cradle with the two screws and
rubber washers.
Mounting the handset and speaker connector
To mount the handset and speaker connector:
 Use cable ties or screws to secure the handset and speaker
connector in a suitable location.
Mounting the RFU
CAUTION: If you are transferring a fixed station to a mobile
station and you have installed rubber feet to the
bottom of the RFU, you must remove the rubber feet
before installing it into the mounting cradle.
To mount the RFU:
 Secure the mounting cradle to the surface with at least four
screws, one in each corner of the cradle.
NOTE: Ensure there is sufficient space at the rear of
the cradle to clear the RFU heatsink.
 If the key is locked to the base of the cradle, flip the key
away from the base until it can be rotated (see Figure 27),
then rotate the key in a counterclockwise direction.
 Place the RFU into the cradle and push it under the tabs at
the rear of the cradle, then hold the clamp against the front
of the RFU.
 Rotate the key clockwise, then push the key toward the base
of the cradle to lock the RFU into position.