User's Manual

DATA OPTIONS
INTERNAL DATA MODEM (2400 BIT/S)
316 E
NVOY™ TRANSCEIVER REFERENCE MANUAL
Pinging the modem from the computer
To ping the modem:
 Connect the computer to the control point and ensure that the transceiver is
switched on.
 Start a Command Prompt session on the computer.
 Type ping followed by the IP address of the connected control point.
For example, type ping 192.168.234.1
If the ping is OK, the modem is ready for use.
If the ping times out:
• check the cable between the computer and the control point
• check the IP address of the USB interface on the control point
 Check the communication between the computer and modem at each station in
the data network.
Viewing COM port setting in VCOM
When VCOM launches, it assigns a virtual COM port for use by internal devices in
the Envoy™ Transceiver. This port number must be set up in other programs used for
communication over HF.
To view the virtual COM port setting:
 Launch the Virtual COM PC Application from Start > All Programs >
Codan.