Reference Manual

Making and receiving calls
2110 SSB Transceiver Reference Manual 181
Calling methods
To make any type of call to a specific station:
1 Decide on the method you want to use to make the call, then use the information in
the following table to start the call.
CAUTION
Depending on the configuration of a NET, a NET call may take several
minutes to establish a link.
NOTE
While a call is being established, the transceiver will show that calling
activity is in progress by flashing the CALL icon in place of the scan
indicator.
NOTE For help with entering text see page 52, Entering and editing text.
If you want to... Do this...
make a call from the
Address List
• go to the entry you want to call in the Address
List
• to use as many details from the entry as possible,
press CALL, or
• to review all details and/or select new ones, hold
CALL
make a call in an emergency • hold for at least 2 seconds
make a new call • press CALL
• select the call type you want to use
• enter the address (including any special ALE
address syntax for ALL, ANY, Group Selective,
NET, and Wildcard calls) of the station(s) you
want to call, or if you are making a Phone call,
enter the phone number you want to call
•press CALL
NOTE
If the ALE Selective Msg entry in the
Control List is enabled, you will be
prompted to press to enter a message.
return a call • press CALL LOGS twice to open the Calls In
Log
• go to the call you want to return
• to use as many details from this call as possible,
press CALL, or
• to review all details and/or select new ones, hold
CALL