Getting Started Guide
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 2110SSB Transceiver compliance
- 2 Your 2110SSB Transceiver
- 3 Preparing the 2110SSB Transceiver for use
- 4 The front panel
- 5 Getting started
- 6 Troubleshooting
- Appendix A— Entering and editing text
- Appendix B— Using Quick Start
- Appendix C— Using the GPS receiver
- Appendix D— Transceiver specifications
- Appendix E— HF radio transmission
- Appendix F— Definitions
- Appendix G— Warranties
- Index
Using Quick Start
52 2110 SSB Transceiver Getting Started Guide
When all the changes have been made, the transceiver
will return to Quick Start.
1 Close Quick Start, if required.
Setting your station self address
To set your station self address:
1 Open Quick Start.
1 Scroll to Set my address, then press .
1 Enter your station self address (maximum of 6 numeric
digits for Codan Selcall, or 15 upper-case/numeric digits
if you have the MIL-STD-188-141B ALE option
installed), then press .
1 Close Quick Start, if required.
NOTE
When Quick Start is available, any self address
that you enter using this method will replace the
previous self address. If you want to enter more
than one self address, and hence disable the
Quick Start features, see the reference material
on the enclosed CD.
NOTE
For help with entering text see page 45,
Entering and editing text.