Getting Started Guide
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 2110SSB Transceiver compliance
- 2 Your 2110SSB Transceiver
- 3 Preparing the 2110SSB Transceiver for use
- 4 The front panel
- 5 Getting started
- 6 Troubleshooting
- Appendix A— Entering and editing text
- Appendix B— Using Quick Start
- Appendix C— Using the GPS receiver
- Appendix D— Transceiver specifications
- Appendix E— HF radio transmission
- Appendix F— Definitions
- Appendix G— Warranties
- Index
Using Quick Start
50 2110 SSB Transceiver Getting Started Guide
Adding/Editing a channel
To add or edit a channel:
1 Open Quick Start.
1 Scroll to Add/Edit channel, then press .
1 Enter the name of the channel that you want to use, then
press .
If you want to use an existing channel, scroll to the
channel, then press .
1 Enter the receive frequency in kilohertz, then press .
1 Enter the transmit frequency in kilohertz, then press .
1 Scroll to the mode combination you want to use, then
press .
The transceiver will return to Quick Start.
1 If you want to add more channels to your transceiver,
scroll to Add/Edit channel and repeat this process.
1 Close Quick Start, if required.
NOTE
For help with entering text see page 45,
Entering and editing text.
NOTE
You can enter the frequency to three
decimal places. Press
*
to enter a decimal
point, then continue with entering the
frequency.
NOTE
If you want to make or receive calls on this
new channel, you must add it to your scan
list.