Getting Started Guide
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 2110SSB Transceiver compliance
- 2 Your 2110SSB Transceiver
- 3 Preparing the 2110SSB Transceiver for use
- 4 The front panel
- 5 Getting started
- 6 Troubleshooting
- Appendix A— Entering and editing text
- Appendix B— Using Quick Start
- Appendix C— Using the GPS receiver
- Appendix D— Transceiver specifications
- Appendix E— HF radio transmission
- Appendix F— Definitions
- Appendix G— Warranties
- Index
Entering and editing text
2110 SSB Transceiver Getting Started Guide 47
Changing between alpha and numerical characters
To change between upper-case and lower-case letters and
numbers in an editable screen:
1 Press # to change the character/case indicator at the
bottom right of the screen from A to a to #.
Moving the cursor
To move the cursor across the text:
1 Use and to move the cursor left and right
respectively.
Inserting text
To insert text:
1 Use and to move the cursor to the point where you
want to insert text (or a space), then press the required
character key.
NOTE
When you are prompted to enter a call
address, the characters that you can enter
are determined by the call systems installed
in the transceiver.